Electric forklifts must have high production efficiency and low operating costs. The significance of using a forklift is to improve production effici...
Electric forklifts must have high production efficiency and low operating costs. The significance of using a forklift is to improve production efficiency, so you must focus on this when buying a forklift. The purchased forklift must have superior performance, and the wear rate of tires and transmission gears, as well as the fuel consumption rate must be reduced. If the drive axle emits messy and continuous noise and the noise increases with the increase in speed, it decreases or disappears when sliding. Generally, it is the noise produced after the bearing is worn. It should be repaired or replaced and re-adjusted.
1. If the driving board makes a rhythmic metal crash during driving, especially when the vehicle speed changes sharply.
2. The noise is very obvious when starting, most of which are caused by too large tooth gap of the basin gear, and the tooth gap should be adjusted.
3. A continuous "buzzing" sound and heating of the drive axle are found during exercise, which may be caused by the bearing is too tight or the tooth gap is too small, or it may be poor lubrication. You should stop for inspection and add lubricating oil if the above phenomenon occurs. Should check and adjust the bearing tightness or gear clearance.
4. If the vehicle suddenly makes a "gnaw" or "quack" during driving, it is usually because the basin gear set is broken or the bearing falls apart. It should be checked and repaired immediately.
Ningbo Yinzhou Walsun Machinery Factory is a professional manufacturer of logistics handling equipment. Our main products are manual electric hydraulic pallet trucks ,Manual electric table trucks, stackers, ect. For many years, in line with the concept of quality management, it has invested a large amount of money to add various imported equipment.